N/A

Non-flammable, very safe.
Low residual transfer.
Water clean up.
Very low VOC’s
Available in clear or custom colors.

N/A

All surfaces to be coated must be free of any oils, dust, mold release or loose particles.

USE ADEQUATE VENTILATION. GENTLY MIX BEFORE EACH USE.

Notched Trowel-
Depending on porousity, texture of surface being applied to and level of non-skid performance needed, determine the proper depth of notch by testing various thicknesses. Once this has been determined apply liberal amount of F-873 to one end of item being coated and draw trowel across the surface. Allow to dry thoroughly before packaging or using.

Brush-
Apply F-873 with brush working back and forth making sure to overlap to achive even and desired thickness and texture. Allow to dry thoroughly before packaging or using.

Roller-
Apply F-873 with roller working back and forth making sure to overlap to achive even and desried thickness and texture. Allow to dry thoroughly before packaging or using.

Screening-
Apply F-873 by screen print method by applying a liberal amount of F-873 to properly sized mesh screen [must test to determine size for your application], press F-873 through screen using a plastic squeegee directly onto the substrate being coated. Lift screen from substrate. Allow to dry thoroughly before packaging or using.

Clean Up-
Use water for immediate clean up.

N/A

Allow at least an overnight dry before stacking or storing coated items unless you’ve accelerated drying with heat. After allowing to air dry for 5 minutes, a recommended heat for drying is 100ºF-150ºF with moving air until thoroughly dry is recommeneded. Always use proper ventilation and protection.

N/A

For Industrial Use Only.

We cannot anticipate all conditions under which this information and our products, or the products of other manufacturers in combination with our products, may be used. We accept no responsibility for results obtained by the applications of this information or the safety and suitability of our products, either alone or in combination with other product combination for their own purposes. Unless otherwise agreed in writing, we sell the products without warranty, and buyers and users assume all responsibility and liability for loss or damage arising from the handling and use of our products whether used alone or in combination with other products. Ever changing V.O.C. regulations in your area may require you to contact local authorities for proper use and/or disposal of this product. Should you need further assistance, please contact PLASTI DIP INTERNATIONAL technical service.

PDC and eccs are registered trademarks of PLASTI DIP INTERNATIONAL
Performix and logo are trademarks of PLASTI DIP INTERNATIONAL
BINKS is a registered trademark of BINKS MFG. CO., Franklin Park, IL