N/A

Non-flammable.
Very safe and easy to use.
Water clean up.

N/A

All surfaces to be coated must be free of any oils, dust, mold release or loose foam particles.

USE ADEQUATE VENTILATION. GENTLY MIX BEFORE EACH USE.

N/A

Binks® model 2100 or equivalent conventional spray gun.
Nozzle: 66SS
Cap: 66SS
Needle: 565
Material: 20 psi
Atomization: 10-15 psi
Dilution: not recommended
Clean up: immediately with water – if allowed to dry, use Acetone or M.E.K

N/A

A dry film thickness of 5-10 minimum is recommeneded for best results. Best results are achieved when liquid temperature of F-1061 is between 70-75 F and air temperature is 70-80 F. Allow at least overnight dry before stacking or storing coated items unless you’ve accelerated curing with mild heat. Always use proper ventilation and protection.

N/A

For Industrial Use Only.

We cannot anticipate all conditions under which this information and our products, or the products of other manufacturers in combination with our products, may be used. We accept no responsibility for results obtained by the applications of this information or the safety and suitability of our products, either alone or in combination with other product combination for their own purposes. Unless otherwise agreed in writing, we sell the products without warranty, and buyers and users assume all responsibility and liability for loss or damage arising from the handling and use of our products whether used alone or in combination with other products. Ever changing V.O.C. regulations in your area may require you to contact local authorities for proper use and/or disposal of this product. Should you need further assistance, please contact PLASTI DIP INTERNATIONAL technical service.

PDC is a registered trademark of PLASTI DIP INTERNATIONAL
Performix and logo are trademarks of PLASTI DIP INTERNATIONAL
Hypalon is a registered trademark of DuPont, Wilmington, DE
Cowles is a registered trademark of Morehouse-COWLES, Inc.
BINKS is a registered trademark of BINKS MFG. CO., Franklin Park, IL
3M is a registered trademark of 3M St. Paul, MN.

N/A

F-1061 is water based and like all water based coatings and paints can be sensitive to prolonged contact with water. If F-1061 does come in contact with water, it is normal for the color to change [lighter] after prolonged contact. After drying the color will return to its original shade. If products being coated require greater moisture resistance its recommeneded you contact Technical Service for our high performance cross linked finish.

N/A

1. Whether edge spraying individual pieces or stacking several pieces at a time, it’s recommended you create templates (PE or PP work best) to place on top of pieces being sprayed. This will protect the top surface from overspray and help hold down the piece(s) while spraying.
2. Holding the spray gun 6”-12” from the surface, using a 4”-6” pattern at a 90 degree angle, apply heavy, wet, overlapping coats, moving slowly over the length of the surface being coated, being sure to “flood” the surface saturating the cell structure.
3. Separate pieces and allow to air dry to the touch. Once dry to the touch, either repeat the process or place in mild heat and air movement (80-100°F) for 15 minutes to speed the curing process.
4. If a second coat is required, it’s recommended to apply the second spray coat, then flip the pieces over and allow them to dry. By flipping the pieces over, you will achieve better sealing and coverage due to the “wedge effect” of the coating during drying. Once dry to the touch, you may place in mild heat and air movement (80-100°F) for 15 minutes to speed the curing process or leave the pieces to dry overnight.