N/A Intended for use in molds with starting temps 70-90ºF.
Super fast dry time
Custom color matching
Very good chlorine, bromine and other harsh chemical resistance.

N/A In House Test Results: Further testing being done. Good- Excellent common household chemicals.

N/A For Industrial Use Only.

We cannot anticipate all conditions under which this information and our products, or the products of other manufacturers in combination with our products, may be used. We accept no responsibility for results obtained by the applications of this information or the safety and suitability of our products, either alone or in combination with other product combination for their own purposes. Unless otherwise agreed in writing, we sell the products without warranty, and buyers and users assume all responsibility and liability for loss or damage arising from the handling and use of our products whether used alone or in combination with other products. Ever changing V.O.C. regulations in your area may require you to contact local authorities for proper use and/or disposal of this product. Should you need further assistance, please contact PLASTI DIP INTERNATIONAL technical service.

PDC is a registered trademark of PLASTI DIP INTERNATIONAL
Performix and logo are trademarks of PLASTI DIP INTERNATIONAL
BINKS is a registered trademark of BINKS MFG. CO., Franklin Park, IL

N/A MIX WELL BEFORE USE.
All surfaces to be coated must be free of any oils, dust or loose foam particles. It is recommended that the entire foam surface be wiped clean using a lint free cloth with either NMP [n-methyl-pyroliodone] or MEK [methyl ethyl ketone] solvent. Allow solvent to flash before coating.

USE ADEQUATE VENTILATION.

N/A GENTLY MIX BEFORE SPRAYING.
Pressure pot/conventional sprayers may be used.

F-899- Apply wet, overlapping coats, holding gun 6"-12" from surface, using 4"-6" pattern. Allow 30 minutes minimum dry time before applying additional coats or turning part over. It’s recommended that 2-3 coats be applied for best results. Allow coated finished part to dry 4 to 6 hours minimum [depending on mil thickness applied] before handling and 24 hours minimum before packaging or shipping.

N/A Binks® model 2100 gun
Nozzle: 63B
Cap: 63PB
Needle: 363A
Material: 20psi
Atomization: 10-25psi
Dilution: not recommended
Clean up: Glycol Ether EB or quality lacquer thinner.

N/A Always use proper ventilation and protection. Allow overnight drying whenever possible. Avoid excessive air movement, heat or humidity. To accelerate drying of coated parts: air dry coated part 10-15 minutes then force dry 30-60 minutes at 90-120º F being careful not to distort or damage foam substrate. Contact foam manufacturer for guidelines.

N/A EVA foam has a tendency to out gass which can cause delamination or blistering of the coating. Use caution when shipping coated parts by air freight or into hot conditions too soon after completing part.