N/A Intended for use in molds with starting temp 115-145ºF
Wide selection of colors.
Single component - no catalyst.
Fast dry time.
DMF free

N/A To accelerate cycle times preheat the mold between115-145ºF.

For Industrial Use Only.

We cannot anticipate all conditions under which this information and our products, or the products of other manufacturers in combination with our products, may be used. We accept no responsibility for results obtained by the applications of this information or the safety and suitability of our products, either alone or in combination with other product combination for their own purposes. Unless otherwise agreed in writing, we sell the products without warranty, and buyers and users assume all responsibility and liability for loss or damage arising from the handling and use of our products whether used alone or in combination with other products. Ever changing V.O.C. regulations in your area may require you to contact local authorities for proper use and/or disposal of this product. Should you need further assistance, please contact PLAST DIP INTERNATIONAL technical service.

PDC is a registered trademark of PLASTI DIP INTERNATIONAL
Performix and logo are trademarks of PLASTI DIP INTERNATIONAL
BINKS is a registered trademark of BINKS MFG. CO., Franklin Park, IL

N/A For best results avoid using silicone lubricants or excessive amounts of wax on mold surfaces. Always ensure the mold release being used is "paint compatible" or "paintable" to minimize adhesion issues.

USE ADEQUATE VENTILATION.

N/A Binks® model 2100 gun
Nozzle: 66SS
Cap: 66SD
Needle: 565
Material: 10-12 psi
Atomization: 40-60 psi depending on spray pattern and distance from mold applied
Dilution: None Required
Clean up: Acetone or MEK

N/A Always mix before spraying. Always use proper ventilation and protection.

N/A QUALITY CONTROL RECOMMENDATIONS FOR SPRAY APPLICATION.
F-1059 IMC will thicken/settle during storage, requiring thorough remixing before use each day. Use a high speed sheer blade for best results. You can find this equipment at our company's website or for 5 gallon pails use a high rpm 3/8" air drill, threaded shaft with 4" circular saw blade and double nut with washers. Mix the pail for 2-3 minutes each day before use or every 4 hours during use for best results.

Avoid making solvent additions before mixing. Check viscosity. Some adjustments may be necessary for your particular use. Contact technical service for specific applications.

Spraying in mold: Hold spray gun 6"-10" from the mold surface, apply F-1059 IMC in a uniform wet coat using an overlapping motion. Be sure to cover the entire mold surface evenly to avoid finish variations. Check dry coating thickness periodically to ensure a minimum thickness of 1/2 mil to as much as 2 mils are achieved for best results.