N/A

MIX WELL BEFORE USE.
All surfaces to be coated must be free of any oils, dust or loose foam particles.

USE ADEQUATE VENTILATION.

N/A

Make sure coating (F-818) is dry; submerge and remove as done with F-818 and allow to run off. Air dry until completely dry. If faster drying is preferred, allow to air dry 30-60 seconds, then place in mild heat , 95ºF-120ºF, with mild air movement. Make sure heat source is safe for this use and that you ventilate properly. Drying will typically take 10-15 minutes, air dry 30-45 minutes. Apply 1-2 coats or to desired thickness.

N/A

GENTLY MIX BEFORE SPRAYING.
Pressure pot/conventional sprayers may be used. Apply wet, overlapping coats, holding gun 6"-12" from surface, using 4"-6" pattern. Allow 10-20 minutes minimum dry time before applying additional coats or turning part over. If applying F-760 over F-818 coated surface, a wet thin coat will be sufficient. To speed drying of F- 760, allow to air dry 5 minutes, then place in mild heat, 95°F-120°F, with mild air movement, until completely dry. Make sure heat source is safe for this use and that you ventilate properly. Recommended dry film thickness is 1-3 mils.

N/A

Binks® model 2100 gun
Material: 20psi
Nozzle: 63B
Atomization: 10-25psi
Cap: 63PB
Dilution: As Needed
Needle: 363A
Clean up: Methyl Ethyl Ketone, M.I.B.K., Toluene or Xylene.

Industrial/commercial airless equipment may be used. Use as described above.
Tip size: 0.011-0.019
Pressure: As Needed
Dilution: Not Recommended

N/A

Recommended thinners, M.I.B.K or Xylene. Always use proper ventilation and protection. When using a dip tank, always leave at least 6” from fluid surface to tank top to minimize skinning over. Allow overnight drying whenever possible. Avoid excessive air movement, heat or humidity.

N/A

For Industrial Use Only

We cannot anticipate all conditions under which this information and our products, or the products of other manufacturers in combination with our products, may be used. We accept no responsibility for results obtained by the applications of this information or the safety and suitability of our products, either alone or in combination with other product combination for their own purposes. Unless otherwise agreed in writing, we sell the products without warranty, and buyers and users assume all responsibility and liability for loss or damage arising from the handling and use of our products whether used alone or in combination with other products. Ever changing V.O.C. regulations in your area may require you to contact local authorities for proper use and/or disposal of this product. Should you need further assistance, please contact PLASTI DIP INTERNATIONAL technical service

PDC is a registered trademark of PLASTI DIP INTERNATIONAL
Performix and logo are trademarks of PLASTI DIP INTERNATIONAL
BINKS is a registered trademark of BINKS MFG. CO., Franklin Park, IL