Skip To Content
ISO 9001:2015
mail_outline contact@performixcoatings.com call 1-800-969-5432 ext 6104 search

Catalog

Request Information

F-950 EVA Foam Primer is an air dry EVA solvent based primer which has been specifically formulated to increase adhesion of Muraculon spray coatings to EVA foams. F-950 EVA Foam Primer is especially effective in increasing adhesion to fusion molded and normally fabricated EVA foams.

F-950 EVA Foam Primer is used in manufacturing of patient positioning products, athletic padding and industrial applications.

Unit of Measure

Technical Specs

Brands

 N/A Performix®

Solids Weight

 N/A 18 %

Shelf Life

 N/A 1+ years at 77 ºF unopened container

Coverage

 N/A 200 ft²/gal

Finsh/Color

 N/A Amber

Surface Preparations

N/A

MIX WELL BEFORE USE.
All surfaces to be coated must be free of any oils, dust or loose foam particles.

USE ADEQUATE VENTILATION.

Spraying

N/A

SHEER MIX BEFORE SPRAYING.
Siphon Cup Gun/ Pressure pot sprayers may be used. Apply light [damp] overlapping coats, holding gun 6"-12" from surface, using 4"-6" pattern. Be sure to coat the entire surface and allow to dry 30 minutes minimum or until tacky to touch before applying Muraculon Coating.

Recommended Equipment and Settings

N/A

Binks® model 2100 gun
Nozzle: 63B
Cap: 63PB
Needle: 363A
Material: 20psi
Atomization: 10-25psi
Dilution: not recommended
Clean up: Toluene

Note

N/A

For Industrial Use Only.

We cannot anticipate all conditions under which this information and our products, or the products of other manufacturers in combination with our products, may be used. We accept no responsibility for results obtained by the applications of this information or the safety and suitability of our products, either alone or in combination with other product combination for their own purposes. Unless otherwise agreed in writing, we sell the products without warranty, and buyers and users assume all responsibility and liability for loss or damage arising from the handling and use of our products whether used alone or in combination with other products. Ever changing V.O.C. regulations in your area may require you to contact local authorities for proper use and/or disposal of this product. Should you need further assistance, please contact PLASTI DIP INTERNATIONAL technical service

PDC is a registered trademark of PLASTI DIP INTERNATIONAL
Performix and logo are trademarks of PLASTI DIP INTERNATIONAL
BINKS is a registered trademark of BINKS MFG. CO., Franklin Park, IL