N/A Non-flammable, very safe
Very low VOC's
Technical support second to none.
Unmatched strength, durability and dry time.

N/A All surfaces to be coated must be free of any oils, dust, mold release or loose foam particles.

USE ADEQUATE VENTILATION. GENTLY MIX BEFORE EACH USE.

N/A IMC (in mold coating): Make sure tool/ mold is clean and free of mold release unless release has been tested and approved for suitability. Spray apply light even coat making sure to cover all surfaces evenly and completely. Allow coating to tack before adding foam mixture. The use of heated tool/ molds, external heat and air movement is recommended to speed and ensure coating is tacky as quickly as possible. Allow adequate time for foam mixture to complete cycle and for coating to set up. Remove from tool/ mold carefully. Coated part should remove easily without damage to coating skin. If coating sticks to tool/ mold, allow for longer tack time or speed drying process. If difficulty persists, contact Technical Support for assistance.

PMC (post mold coating) or applied directly to other foams:
Tack coat: Apply light, overlapping coats, holding gun 12"-24" from surface, using an 8"-12" pattern. Allow adequate dry time before applying Finish coat.
Finish coat: Apply wet overlapping coats to desired film thickness. Multiple coats can be applied. Allow adequate dry time between coats or handling.

N/A Binks® model 2100 gun or equivalent
Nozzle: 66SS
Cap: 66SS
Needle: 565
Material: 20 psi
Atomization: 10-25 psi
Dilution: not recommended
Clean up: immediately with water - if allowed to dry, use Acetone or M.E.K.

Airless or air assisted airless equipment may be used. Dilution is not suggested. Gently mix before spraying. Apply wet, overlapping coats, holding gun 12"-24" from surface, using 6"-12" pattern. Allow to completely dry before recoating or turning item over.
Tip size: 0.011-0.026
Pressure: As Needed
Dilution: Not Recommended
Clean up: immediately with water - if allowed to dry, use Acetone or M.E.K.

N/A A dry film thickness of 6-8 mils should be used on all items; 8-10 mils on high wear items. Allow at least an overnight dry before stacking or storing coated items unless you’ve accelerated drying with heat. After allowing to air dry for 30 minutes, a recommended heat for drying is 100ºF-150ºF with moving air. Always use proper ventilation and protection.

N/A For Industrial Use Only.

We cannot anticipate all conditions under which this information and our products, or the products of other manufacturers in combination with our products, may be used. We accept no responsibility for results obtained by the applications of this information or the safety and suitability of our products, either alone or in combination with other product combination for their own purposes. Unless otherwise agreed in writing, we sell the products without warranty, and buyers and users assume all responsibility and liability for loss or damage arising from the handling and use of our products whether used alone or in combination with other products. Ever changing V.O.C. regulations in your area may require you to contact local authorities for proper use and/or disposal of this product. Should you need further assistance, please contact PLASTI DIP INTERNATIONAL technical service.

PDC and eccs are registered trademarks of PLASTI DIP INTERNATIONAL
Performix and logo are trademarks of PLASTI DIP INTERNATIONAL
BINKS is a registered trademark of BINKS MFG. CO., Franklin Park, IL