N/A All surfaces to be coated must be free of all oils, grease, dirt, wax and must be dry. Be sure to always properly mask off areas that are not to be coated to minimize overspray clean up or damage to other surfaces or finishes. Always test F-1068 on surface to be coated for ease of removal.

MIX WELL BEFORE USE. USE ADEQUATE VENTILATION.

N/A Overspray will NOT peel. Wet continuous coats must be applied for easy removal.
Turbine Sprayer - Using a Wagner MotoCoat® sprayer (or similar) turbine sprayer. Gently mix before each use. If spraying a small area, and turbine has a fan speed selector, use low setting. If applying to a larger area, set speed selector to high setting for improved atomization. Apply wet, overlapping coats, holding gun 6"-12" from surface, using a 4"- 6" pattern. Allow to dry to touch before applying additional coats to desired thickness. One wet coat is approximately 6-8 mils wet (3-4 mils dry) and most applications require 6-8 mils dry for easy peel and adequate protection. Minimum two full coats are recommended for most applications.

Pressure pot/conventional sprayers may be used. Gently mix before each use. Apply wet, overlapping coats, holding gun 6"-12" from surface, using a 4"- 6" pattern. Allow to dry to touch before applying additional coats to desired thickness. One wet coat is approximately 6-8 mils wet (3-4 mils dry) and most applications require 6-8 mils dry for easy peel and removal. Minimum two full coats are recommended for most applications

N/A Gun: Binks® model 2100
Nozzle: 63B
Cap: 63PB or 66SD-3 for heavier build up
Needle: 663A
Material: 25psi
Atomization: 15-25psi

Dilution: None Required
Clean up: water, alcohol if allowed to dry

Industrial/commercial airless equipment may be used. Use as described above.
Tip sizes: 0.011 - 0.019
Pressure: As Needed
Dilution: As Needed

N/A Gently mix before each use. Apply wet overlapping coats using a foam brush, pad or roller. Allow to dry to touch before applying additional coats to desired thickness. Apply 3-4 coats to leave a 6-8 mil dry film thickness for easy peel and removal.

N/A A dry film thickness of 6-8 mils is recommended for best results. Allow overnight drying whenever possible. To speed drying, mild heat (95°F-110°F) and air flow may be used. Do not stack or store parts in contact with each other. Avoid excessive air movement, heat or humidity. Always use proper ventilation and protection.

N/A For Industrial Use Only.

We cannot anticipate all conditions under which this information and our products, or the products of other manufacturers in combination with our products, may be used. We accept no responsibility for results obtained by the applications of this information or the safety and suitability of our products, either alone or in combination with other product combination for their own purposes. Unless otherwise agreed in writing, we sell the products without warranty, and buyers and users assume all responsibility and liability for loss or damage arising from the handling and use of our products whether used alone or in combination with other products. Ever changing V.O.C. regulations in your area may require you to contact local authorities for proper use and/or disposal of this product. Should you need further assistance, please contact PLASTI DIP INTERNATIONAL technical service.

PLASTI DIP, HCF, eccs, Performix and logo are registered trademarks of PLASTI DIP INTERNATIONAL
BINKS is a registered trademark of BINKS MFG. CO., Franklin Park, IL
MOTOCOAT is a registered trademark of Wagner Spray Tech Corporation Plymouth, MN.