N/A MIX WELL BEFORE USE.
All surfaces to be coated must be free of any oils, loose rust, dirt or dust. A sandblasted or rough surface allows for best adhesion of PLASTI DIP® PRIMER/AIM Compliant, to metal.

USE ADEQUATE VENTILATION.

N/A Wagner Motocoat Sprayer or equivalent is recommended.
Using the small Wagner Motocoat spray gun found in the kit (not large gun), fill cup with adequately mixed PLASTI DIP® PRIMER/AIM Compliant. Set turbine fan on high setting and turn the paint volume knob on trigger all the way in (fully open when triggered) to check paint flow when spraying. On a test surface, holding spray gun 6"-12" from surface and pull trigger sweeping left to right and making sure you are applying a medium pass. If too dry and not wetting out, you may be holding the gun too far away from substrate, causing dry spray. If too wet or sagging, try pulling gun back from surface, closer to 12". If still too wet, turn paint volume knob out to reduce paint flow when gun is fully triggered. Adjust paint volume and distance from surface to obtain best results.
Once gun is set, apply medium/wet overlapping coats, holding gun 6"-12" from surface, using a 4"-6" pattern. Only one coat is recommended. Allow PLASTI DIP® PRIMER/AIM Compliant to dry to touch (30-60 minutes) before applying PLASTI DIP®/AIM Compliant Coating/RTS.

N/A Gently mix before each use. Do not introduce air bubbles. Insert item 1" every 5 seconds. Remove at same rate. Allow 60 minutes (dry to the touch) before applying PLASTI DIP®/AIM Compliant Coating/RTS.

N/A Gently mix before each use. Apply wet overlapping coats using a soft natural bristle brush. Allow 30-40 minutes (dry to the touch) before applying PLASTI DIP®/AIM Compliant Coating/RTS.

N/A Clean Up: Aromatic 100 or Methyl Acetate exempt solvents only. A dry film thickness of 1 mil is recommended for best results. Avoid excessive air movement, heat or humidity. Always use proper ventilation and protection.

N/A For Industrial Use Only.

We cannot anticipate all conditions under which this information and our products, or the products of other manufacturers in combination with our products, may be used. We accept no responsibility for results obtained by the applications of this information or the safety and suitability of our products, either alone or in combination with other product combination for their own purposes. Unless otherwise agreed in writing, we sell the products without warranty, and buyers and users assume all responsibility and liability for loss or damage arising from the handling and use of our products whether used alone or in combination with other products. Ever changing V.O.C. regulations in your area may require you to contact local authorities for proper use and/or disposal of this product. Should you need further assistance, please contact PLAST DIP INTERNATIONAL technical service.

eccs is a registered trademarks of PLASTI DIP INTERNATIONAL
Performix and logo are trademarks of PLASTI DIP INTERNATIONAL
BINKS is a registered trademark of BINKS MFG. CO., Franklin Park, IL
Wagner is a registered trademark of Wagner Spray Tech Corp Plymouth, MN

eccs is a registered trademarks of PLASTI DIP® INTERNATIONAL
Performix and logo are trademarks of PLASTI DIP INTERNATIONAL
BINKS is a registered trademark of BINKS MFG. CO., Franklin Park, IL
Wagner is a registered trademark of Wagner Spray Tech Corp Plymouth, MN